Details
RSS™ screws which are 3"1/8 and longer have a six threaded CEE thread that enlarges the screw hole for the non-threaded portion of the fastener, allowing the wood to settle easily and increasing the screw’s drawing strength. The CEE thread also reduces the likelihood of splitting the wood and the friction on the screw shank which can result in lowering the driving torque.
Our round head with built-in shield (washer type head) has no sharp edges such as on conventional lag screws. The added shoulder (nominal diameter) underneath the washer has the ability to center the RSS™ screw in pre-drilled hardware like hinges and connector plates. Short lengths of the RSS™ may also be used to install wire diamond mesh for stucco buildings.
The #30 Star Drive will deliver approximately 650 lbf of energy, eliminating the need to drill a pilot hole.
The RSS™ screw is the only lag screw replacement of its kind.
RSS™ Screws #10 & #1/4 take a T-25 bit.
RSS™ Screws #5/16 & #3/8 take a T-30 bit.
Additional Information
| Manufacturer | GRK |
|---|---|
| Manufacturer Link | http://www.grkfasteners.com/en/RSS_1_2_information.htm |
You may also be interested in the following product(s)
GRK R4 Multi Purpose Screw
$3.19
|
GRK RT Composite Trim Head Screw
$6.99
|
GRK FIN/Trim Head Screw
$5.99
|
Check items to add to the cart or select all
You have no items in your shopping cart.
You have no items to compare.
