WiseCable Heritage WC-HS Series

The WiseCable® Heritage WC-HS Series is a budget-friendly cable railing kit for any type of wood post as outside to outside fitting on a straight level run or on a pitch or stairs. The tensioning device is a 2-7/8” long threaded stud which installs on the back side of one end post. A pull lock fitting is installed through the other end.

This through-the-post configuration is the only scenario in which the economical threaded stud kits may be used. These threaded stud kits are more economical than the WiseCable® Estate WC-ES Series, but the threaded studs are a basic, functional fitting, not a hide-in-the-post solution. A brass hex nut and some metal thread will extend beyond the back of the post on one end. (Brass hex nut end cap sold separately.)

Use the WiseCable® Heritage WC-HS Series for decks with dedicated end posts for each run where the posts are situated such that, the back sides of the posts are all accessible. Meaning you can use a through-the-post configuration. This is both the most economical solution and where the fittings are least visible.

Tools needed for WiseCable® Heritage WC-HS Series on level straight runs and on a pitch or stairs:

• 5/32 drill bit
• 9/32 drill bit for threaded stud installation
• 29/64 drill bit for pull lock installation
• 7/32 wrench for holding the stud
• 7/16 wrench for tightening jam nuts
• Cable cutting tool
• If using post protector tubes, 1/4 drill bit