WiseCable Estate WC-ES Series

WiseCable Estate WC-ES Series for any type of wood post as outside to outside fitting on a straight level run or on a pitch or stairs. The tensioning device is a 3½” long invisible receiver, which installs through the wood post on one end. The invisible receiver with invisible stud combination is a concealed, swaged, tensioning, through-the-post-mounted fitting that is suitable for a level or pitched runs and is available for wood applications. A pull lock fitting is installed through the other end. Pre Assembled Kits from 5' to 50' with all the hardware included. (Equipment and accessories sold separately) For post protector tubes, see Cable Railing Accessories page

Use the WiseCable® Estate WC-ES Series for decks with dedicated end posts for each run where the posts are situated such that, the back sides of the posts are all accessible. Meaning you can use a through-the-post configuration. This fitting is placed and concealed within a pre-drilled hole in the wood end post (a minimum of 3” of clearance must exist on the back side of the post to allow installation of the receiver). The stud is swaged onto one end of the cable and is inserted and threaded into the receiver installed in the end post. Tension is created by rotating the receiver (with a hex wrench inserted into its broached end) and drawing the stud into the receiver.

When taking the WiseCable® Estate WC-ES Series cable railing through a corner, do not bend the cable past 45⁰ at any one time. If turning 90⁰, a 2-step turn using a double corner post configuration is required as illustrated in the corner post instructions (VIEW HERE)

Tools needed for Estate WC-ES Series on level straight runs:

• 5/32 drill bit if 1/8” cable, 7/32 if 3/16”
• 29/64 drill bit for receiver and pull lock installation
• 7/16 wrench for tensioning adjustable body
• Cable cutting tool
• If using post protector tubes, 1/4 drill bit